top of page
Q-Bar Trunking System
Q-Bar is a complete solution for connecting Transformers or Generators to LV/MV Panels. Q-Bar can also be used to distribute power to the rest of the electrical loads. All Bus-bar pieces are connected together by Joints. Thanks to the unique joint design that ensures maintenance free installation, in addition to the special Belleville spring washers that are used to to maintain the pressure at the joints.
Anchor 1
 QBar-Feeder Length |  QBar-Distribution Length |
|---|---|
 QBar-Edgewise Elbows |  QBar-Flatwise Elbows |
 QBar-Flange Units |  QBar-Tap-Off Units |
 QBar-Converter Box |
Q-Bar Specifications
-
Painted Extruded Aluminum Housing
With RAL7035 -
High Conductivity Tinned Copper With Purity Over Than 99.9%
-
Fully Complied With IEC Standards and
tested by DEKRA -
IP55 up to IP67
-
All ratings are available from 400A up to 4000A.
-
Double headed nut at the joints with belleville springs.
-
Double Layer Of Insulation.
-
Insulation Degree up to 300 deg C.
-
Warranty Up To 5 Years.
bottom of page